|
BOOCCA Averaging Pitot tube BF10-200 Flow Sensors Screwed Connection On-line Installation type
As an insertion-type flow meter, it is quickly and easily installed through a small hole drilled into a pipe or duct. As a mechanical device without electronics or moving parts, it doesn’t suffer from electronic drift or physical wear, making it a dependable, repeatable primary element requiring no periodic recalibration. Maintenance may be as simple as inspect and replace as needed.
BF10-200 screw joint online install type can be installed & repaired without stopping production. Especially fit for that dirty medium, need repair periodic or can’t stop production measure point, such as gas, large diameter groundwater. Have single pole drive type and double pole drive which used for high pressure. For large diameter such as too small install space, straight pipe long enough or for the cost reason, can chose the online install part insert type.
· Accuracy: ±0.5%~1.0%
· Repeat accuracy: ±0.1%
· Suitable pipe diameter: 25~12000mm.
· Standard Grade: Online installation temperature less than 121℃, pressure less than 2.5Mpa
Single pole Max. ANSI 150# 0.65Mpa@396℃ 1.89Mpa@38℃
·Joint type: Wire press and expand sealed screw joint online install type
· Application: Commonly used for wind, water, gas etc. measurement. | 
Flow instruments
